The most important electrical maintenance of the water bottle filling machine is daily maintenance.
1. Check before power on.
Check the power supply of the water bottling equipment every day before starting the machine for problems, and check whether the insulation outside the power supply is damaged or disconnected, and make sure that these places are all right. After there are no problems, start running the equipment, this is not only for the pure water bottle filling machine maintenance, but also for the safety of the operator.
2. Check the motor daily.
It is said that there is no need to disassemble it every day for maintenance, and the operator should also pay more attention to whether there is noise or poor flow when the motor is running. When this happens, if there is, stop working and start troubleshooting, then work after the final failure. If you work every day, lubricate the motor every once in a while.
3. Pay attention to whether there is abnormal vibration, sound, etc. of the water injector.
If you hear abnormal noise or find abnormal vibration of the water bottle filling machine during the work, you should stop working immediately, and the dyeing technician will deal with it. If you do not deal with it in time. May cause irreversible damage to the device.
4. Review at the end of the work.
Turn off the power and pull out the plug before leaving get off work every day to ensure that the machine is clean and the electricity is normal, which is convenient for simple review at work the next day without affecting the progress of the work.